| PART |
Description |
Maker |
| MDS108 MDS108A MDS108AL |
9-Port 10/100 Mbs Ethernet Switch
Unmanaged 9-Port 10/100 Mbps Ethernet Switch 非托端口10/100 Mbps以太网交换机
|
Zarlink Semiconductor, Inc.
Zarlink Semiconductor Inc.
|
| RF-7800W-PA440 |
DESIGNED FOR THE RF-7800W-OU440 BROADBAND ETHERNET RADIO
|
Harris Corporation
|
| ACD81024 |
24 ports single chip 10Base-T ethernet switch designed for desktop environment.
|
Advanced Communication Devices
|
| AC207 |
From old datasheet system
8-PORT ULTRA LOW POWER 10/100 ETHERNET BRIDGED REPEATER
8-Port 10/100 Ethernet Bridged Repeater
|
List of Unclassifed Manufacturers
Electronic Theatre Controls, Inc.
ETC
Broadcom
|
| LAN9312 LAN9210 |
High Performance Two Port 10/100 Managed Ethernet Switch with 32-Bit Non-PCI CPU Interface
Small Form Factor Single- Chip Ethernet Controller with HP Auto-MDIX
|
SMSC Corporation
|
| DNCM01 |
10/100 Ethernet MAC ASIC Macrocell(10/100 以太MAC（媒体访问控制） ASIC宏单
|
Lineage Power
|
| G4P109N-B-LF |
Designed for Ethernet 1000 BASE-T, full Quad port applications
|
Bothhand USA, LP.
|
| 16ST8520X-LF |
Designed for 10/100 MB/s transmission over UTP-5 cable
|
Bothhand USA, LP.
|
| 80225 |
10/100 MbpsTX/10BT Ethernet Physical Layer Device (PHY)(10/100 MbpsTX/10BT以太网物理层处理
|
LSI Corporation
|
| VSC7376 |
HawX-G26 - 26-Port 10/100/1000 Managed L2 Ethernet Switch
HAWX-G26⒙ - 26-PORT 10/100/1000 MANAGED L2 ETHERNET SWITCH
|
Vitesse Semiconductor Corporation
|
| ECQV1J473JM ECQV1H474JL ECQV1333JM ECQV1104JM ECQV |
Stacked Metallized Film Capacitor
Designed for application where high density insertion of components is required. CAPACITOR, METALLIZED FILM, PLASTIC, 100 V, 0.015 uF, THROUGH HOLE MOUNT
Designed for application where high density insertion of components is required. CAPACITOR, METALLIZED FILM, PLASTIC, 100 V, 0.01 uF, THROUGH HOLE MOUNT
Designed for application where high density insertion of components is required. CAPACITOR, METALLIZED FILM, PLASTIC, 100 V, 0.27 uF, THROUGH HOLE MOUNT
Designed for application where high density insertion of components is required. CAPACITOR, METALLIZED FILM, PLASTIC, 100 V, 0.15 uF, THROUGH HOLE MOUNT
Designed for application where high density insertion of components is required. CAPACITOR, METALLIZED FILM, PLASTIC, 100 V, 0.47 uF, THROUGH HOLE MOUNT
|
Panasonic, Corp.
Panasonic Corporation
PANASONIC[Panasonic Semiconductor]
|
