View NC7SZ66_992824.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

NC7SZ66 TinyLogic Low Voltage UHS Single SPST Normally Open Analog Switch or 1-Bit Bus Switch
November 1996 Revised March 2002
NC7SZ66 TinyLogic Low Voltage UHS Single SPST Normally Open Analog Switch or 1-Bit Bus Switch
General Description
The NC7SZ66 is a ultra high-speed (UHS) CMOS compatible single-pole/single-throw (SPST) analog switch or 1-bit bus switch. The LOW on resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise. The device is organized as a 1-bit switch with a switch enable (OE) signal. When OE is HIGH, the switch is on and Port A is connected to Port B. When OE is LOW, the switch is open and a high-impedance state exists between the two ports.
Features
s Space saving SOT23 or SC70 5-lead package s Ultra small MicroPak leadless package s Broad VCC Operating Range 1.65V-5.5V s Rail-to-rail signal handling s 5 switch connection between two ports s Minimal propagation delay through the switch s Low ICC s Zero bounce in flow-through mode s Control input compatible with CMOS input levels s >250 MHz -3dB bandwidth
Ordering Code:
Order Number NC7SZ66M5X NC7SZ66P5X NC7SZ66L6X Package Number MA05B MAA05A MAC06 Product Code Top Mark 7Z66 Z66 EE Package Description 5-Lead SOT23, JEDEC MO-178, 1.6mm 5-Lead SC70, EIAJ SC-88a, 1.25mm Wide 6-Lead MicroPak, 1.0mm Wide Supplied As 3k Units on Tape and Reel 3k Units on Tape and Reel 5k Units on Tape and Reel
TinyLogic and MicroPak are trademarks of Fairchild Semiconductor Corporation.
(c) 2002 Fairchild Semiconductor Corporation
DS012177
www.fairchildsemi.com
NC7SZ66
Logic Symbol
Analog Symbol
Pin Descriptions
Pin Names OE A B NC Description Switch Enable Input Bus A I/O Bus B I/O No Connect Pin Assignments for SC70
Connection Diagrams
Function Table
OE L H B0 HIGH-Z State A0 Function Disconnect Connect (Top View) Pad Assignment for MicroPak
(Top Thru View)
www.fairchildsemi.com
2
NC7SZ66
Absolute Maximum Ratings(Note 1)
Supply Voltage (VCC ) DC Switch Voltage (VS) DC Input Voltage (VIN) (Note 2) DC Input Diode Current (IIK) VIN < 0V DC Output (IOUT ) Sink Current DC VCC/GND Current (ICC/IGND) Storage Temperature Range (TSTG) Junction Lead Temperature under Bias (TJ) Junction Lead Temperature (TL) (Soldering, 10 Seconds) Power Dissipation (PD) @ +85C SOT23-5 SC70-5 200 mW 150 mW
-0.5V to +7.0V -0.5V to VCC +0.5V -0.5V to +7.0V -50 mA
128 mA
Recommended Operating Conditions (Note 3)
Power Supply Operating (VCC) Control Input Voltage (VIN) Switch Input Voltage (VIN) Switch Output Voltage (VOUT) Input Rise and Fall Time (tr, tf) Control Input; VCC = 2.3V-3.6V Control Input; VCC = 4.5-5.5V Switch I/O Operating Temperature (TA) Thermal Resistance (JA) SOT23-5 300C/Watt 425C/Watt SC70-5 0 ns/V to 10 ns 0 ns/V to 5 ns 0 ns/V to DC 1.65V to 5.5V 0V to 5.5V 0V to VCC 0V to VCC
100 mA -65C to +150C +150C +260C
-40C to +85C
Note 1: The "Absolute Maximum Ratings" are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum ratings. The "Recommended Operating Conditions" table will define the conditions for actual device operation. Note 2: The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. Note 3: Unused inputs must be held HIGH or LOW. They may not float.
DC Electrical Characteristics
VCC Symbol VIH VIL IIN IOFF RON Parameter HIGH Level Input Voltage LOW Level Input Voltage Control Input Leakage Current OFF Leakage Current Switch On Resistance (Note 4) 4.5 (V) TA= -40C to +85C Min Typ (Note 5) Max Min TA = +25C Typ Max Units Conditions
1.65 to 1.95 0.75 VCC 2.3 to 5.5 1.65 to 1.95 2.3 to 5.5 0 to 5.5 1.65 to 5.5 0.05 0.05 3 5 7 3.0 2.3 1.8 4 10 5 13 7 25 0.7 VCC 0.25 VCC 0.3 VCC 1.0 10.0 7 12 15 9 20 12 30 28 60 6 12 28 125 0.05 10
V V A A 0 VIN 5.5V 0 A, B VCC VIN = 0V, IIN = 30 mA VIN = 2.4V, IIN = 15 mA VIN = 4.5V, IIN = 30 mA VIN = 0V, IIN = 24 mA VIN = 3V, IIN = 24 mA VIN = 0V, IIN = 8 mA VIN = 2.3V, IIN = 8 mA VIN = 0V, IIN = 4 mA VIN = 1.8V, IIN = 4 mA IA = -30 mA, 0 VBn VCC IA = -24 mA, 0 VBn VCC IA = -8 mA, 0 VBn VCC IA = -4 mA, 0 VBn VCC A VIN = VCC or GND IOUT = 0
Rflat
On Resistance Flatness (Note 4)(Note 6)(Note 7)
5.0 3.3 2.5 1.8
ICC
Quiescent Supply Current
1.65 to 5.5
Note 4: Measured by the voltage drop between A and B pins at the indicated current through the switch. On Resistance is determined by the lower of the voltages on the two (A or B) pins. Note 5: All typical values are at the specified VCC, and TA = 25C. Note 6: Parameter is characterized but not tested in production. Note 7: Flatness is defined as the difference between the maximum and minimum value of On Resistance over the specified range of conditions.
3
www.fairchildsemi.com
NC7SZ66
AC Electrical Characteristics
TA= -40C to +85C, Symbol Parameter VCC (V) tPHL, tPLH Propagation Delay Bus to Bus (Note 9) 1.65 to 1.95 2.3-2.7 3.0-3.6 4.5-5.5 tPZL, tPZH Output Enable Time 1.65 to 1.95 2.3-2.7 3.0-3.6 4.5-5.5 tPLZ, tPHZ Output Disable Time 1.65 to 1.95 2.3-2.7 3.0-3.6 4.5-5.5 Q OIRR BW THD Charge Injection (Note 10) Off Isolation (Note 11) -3dB Bandwidth Total Harmonic Distortion (Note 8) 5 .011 % 1.65-5.5 1.65-5.5 1.65-5.5 1.5 1.5 1.5 1.5 1.5 1.5 1.5 1.5 7.0 3.3 2.4 2.0 9.2 5.3 4.0 2.7 0.05 -50 >250 CL= 50 pF, RU= RD = 500 Min Typ (Note 8) Max 4.3 1.2 0.8 0.3 14.2 7.0 5.5 4.5 18.2 9.0 7.0 5.0 ns ns ns pC dB MHz CL = 0.1 nF, VGEN = 0V, RGEN = 0, f = 1 MHz RL = 50 , CL = 5 pF, f = 10 MHz RL = 50 RL = 600 0.5 VP-P f = 600 Hz to 20 KHz
Note 8: All typical values are at the specified VCC, and TA = 25C. Note 9: This parameter is guaranteed by design but is not tested. The switch contributes no propagation delay other than the RC delay of the typical On Resistance of the switch and the 50 pF load capacitance, when driven by an ideal voltage source (zero output impedance). Note 10: Guaranteed by design. Note 11: Off Isolation = 20 log10 [VA/VBN].
Units
Conditions
Figure Number
ns ns ns ns ns ns
VIN = OPEN
Figures 1, 2
VIN = 2 x VCC for tPZL VIN = 0V for tPZH
Figures 1, 2
VIN= 2 x VCC for tPLZ VIN = 0V for tPHZ
Figures 1, 2
Figure 3 Figure 4 Figure 5
Capacitance
Symbol CIN CI/O Parameter Control Pin Input Capacitance Input/Output Capacitance Typ 2 6 Max Units pF pF Conditions VCC = 0V VCC = 5.0V
www.fairchildsemi.com
4
NC7SZ66
AC Loading and Waveforms
Input driven by 50 source terminated in 50 CL includes load and stray capacitance. Input PRR = 1.0 MHz; tw = 500 ns
FIGURE 1. AC Test Circuit
FIGURE 2. AC Waveforms
FIGURE 3. Charge Injection Test
FIGURE 4. Off Isolation
FIGURE 5. Bandwidth
5
www.fairchildsemi.com
NC7SZ66
Tape and Reel Specification
TAPE FORMAT FOR SOT23, SC70 Package Tape Designator M5X, P5X Section Leader (Start End) Carrier Trailer (Hub End) TAPE DIMENSIONS inches (millimeters) Number Cavities 125 (typ) 3000 75 (typ) Cavity Status Empty Filled Empty Cover Tape Status Sealed Sealed Sealed
Package SC70-5 SOT23-5
Tape Size 8 mm 8 mm
DIM A 0.093 (2.35) 0.130 (3.3)
DIM B 0.096 (2.45) 0.130 (3.3)
DIM F (3.5 0.10) (3.5 0.05)
DIM Ko (1.35 0.10) (1.4 0.11)
DIM P1 0.157 (4) 0.157 (4)
DIM W 0.315 0.004 (8 0.1) 0.315 0.012 (8 0.3)
0.138 0.004 0.053 0.004 0.138 0.002 0.055 0.004
www.fairchildsemi.com
6
NC7SZ66
Tape and Reel Specification
TAPE FORMAT FOR MicroPak Package Designator L6X Tape Section Leader (Start End) Carrier Trailer (Hub End) TAPE DIMENSIONS inches (millimeters)
(Continued) Number Cavities 125 (typ) 5000 75 (typ) Cavity Status Empty Filled Empty Cover Tape Status Sealed Sealed Sealed
7
www.fairchildsemi.com
NC7SZ66
Tape and Reel Specification
REEL DIMENSIONS inches (millimeters)
(Continued)
Tape Size 8 mm
A 7.0 (177.8)
B 0.059 (1.50)
C 0.512 (13.00)
D 0.795 (20.20)
N 2.165 (55.00)
W1 0.331 + 0.059/-0.000 (8.40 + 1.50/-0.00)
W2 0.567 (14.40)
W3 W1 + 0.078/-0.039 (W1 + 2.00/-1.00)
www.fairchildsemi.com
8
NC7SZ66
Physical Dimensions inches (millimeters) unless otherwise noted
5-Lead SOT23, JEDEC MO-178, 1.6mm Package Number MA05B
9
www.fairchildsemi.com
NC7SZ66
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
5-Lead SC70, EIAJ SC-88a, 1.25mm Wide Package Number MAA05A
www.fairchildsemi.com
10
NC7SZ66 TinyLogic Low Voltage UHS Single SPST Normally Open Analog Switch or 1-Bit Bus Switch
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
6-Lead MicroPak, 1.0mm Wide Package Number MAC06A Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and Fairchild reserves the right at any time without notice to change said circuitry and specifications. LIFE SUPPORT POLICY FAIRCHILD'S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body, or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the user. 11 2. A critical component in any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. www.fairchildsemi.com
www.fairchildsemi.com

▲Up To Search▲

Price & Availability of NC7SZ66

	To Download NC7SZ66 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .