A96020 Voice Recording Module 20" x 2 sections
Description The A96020 voice recording module offers true single chip solid state storage capability and requires no software or micro-controller support. It provides high quality recording and playback with dual 20 second message. Features Non volatile flash memory technology No battery back up required User friendly, easy to operate Slide switch for record or play back Separate key to trigger message 1 or 2 Low power consumption LED to indicate recording and playback Built-in condenser mic Automatic power down 5-6V Operation Operation Recording 1. Turn slide Switch to REC position, press M1 or M2 to start recording, release key when recording complete. LED will light up during recording. If voice message is longer than 20sec, it will beep twice, LED will turn off and stop recording. 2. If there is a message recorded previously, press REC will erase the previous and record the new one. Play Back 1. Turn slide switch to PLAY position, press M1, or M2 to start play back. The message will be played back from the beginning until ended. During play mode, if key PLAY is pressed, the message will stop immediately. 2. If the newly recorded message is shorter than the previously recorded message, the remaining portion of the previous message will be erased. Standby The module will automatically enter standby mode after recording or playback operation is completed. Connectors and Switches SPK PWR SEL M1 M2 0.1" pitch pin connector for speaker 0.1" pitch pin connector for DC power, note polarity Slide switch for Record/Playback Push button for message 1 Push button for message 2 PCB Layout of the module Size : 34 x 23 mm
Spk Mic GND +6V Rec/Play
Electrical Spec Parameter Operation Voltage Operation Current (8 Speaker connected) Recording Playback Standby Current Typical 6 Max 6.5 Unit V
M1 LED
M2
45 70 200 250
mA
uA
|
