 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| AWT6252 IMT/WCDMA 3.4V/27.5dBm Linear Power Amplifier Module PRELIMINARY DATA SHEET - Rev 1.3 FEATURES * * * * * * * InGaP HBT Technology High Efficiency: 39% Low Quiescent Current: 50 mA Low Leakage Current in Shutdown Mode: <1 A VREF = +2.85 V (+2.75 V min over temp) Optimized for a 50 System Low Profile Miniature Surface Mount Package: 1.56mm Max AWT6252 APPLICATIONS * Dual Mode 3GPP Wireless Handsets M7 Package 10 Pin 4 x 4 x 1.5 mm Surface Mount Module PRODUCT DESCRIPTION The AWT6252 meets the increasing demands for higher output power in 3GPP 1XRTT handsets. The PA module is optimized for VREF = +2.85 V, a requirement for compatibility with the Qualcomm(R) 6250 chipset. The device is manufactured on an advanced InGaP HBT MMIC technology offering state-of-the-art reliability, temperature stability, and ruggedness. Selectable bias modes that optimize efficiency for different output power levels, and a shutdown mode with low leakage current, increase handset talk and standby time. The self-contained 4 x 4 x 1.5 mm surface mount package incorporates matching networks optimized for output power, efficiency, and linearity in a 50 system. GND at slug (pad) VCC RFIN GND 1 2 3 Bias Control 10 VCC 9 8 7 6 GND RFOUT GND GND VMODE 4 VREF 5 Figure 1: Block Diagram 03/2004 AWT6252 GND VCC RFIN GND VMODE VREF 1 2 3 4 5 GND 10 VCC 9 8 7 6 GND RFOUT GND GND Figure 2: Pinout (X-ray Top View) Table 1: Pin Description PIN 1 2 3 4 5 6 7 8 9 10 NAME V CC RFIN GND VMODE VREF GND GND RFOUT GND V CC DESCRIPTION Supply Voltage RF Input Ground Mode Control Voltage Reference Voltage Ground Ground RF Output Ground Supply Voltage 2 PRELIMINARY DATA SHEET - Rev 1.3 03/2004 AWT6252 ELECTRICAL CHARACTERISTICS Table 2: Absolute Minimum and Maximum Ratings PARAMETER Supply Voltage (VCC) Mode Control Voltage (VMODE) Reference Voltage (VREF) RF Input Power (PIN) Storage Temperature (TSTG) MIN 0 0 0 -40 MAX +5 +3.5 +3.5 +10 +150 UNIT V V V dB m C Stresses in excess of the absolute ratings may cause permanent damage. Functional operation is not implied under these conditions. Exposure to absolute ratings for extended periods of time may adversely affect reliability. Table 3: Operating Ranges PARAMETER Operating Frequency (f) Supply Voltage (VCC) Reference Voltage (VREF) Mode Control Voltage (VMODE) RF Output Power (POUT) Case Temperature (TC) MIN 1920 +3.2 +2.75 0 +2.5 0 +27.0 -10 (1) TYP +3.4 +2.85 +2.8 +27.5 - MAX 1980 +4.2 +2.95 +0.5 +3.1 +0.5 +90 UNIT MHz V V V dB m C COMMENTS PA "on" PA "shut down" Low Bias Mode High Bias Mode The device may be operated safely over these conditions; however, parametric performance is guaranteed only over the conditions defined in the electrical specifications. Notes: (1) For operation at TC = +90 oC and VCC = +3.2 V, POUT is derated by 0.5 dB. PRELIMINARY DATA SHEET - Rev 1.3 03/2004 3 AWT6252 Table 4: Electrical Specifications (TC = +25 C, VCC = +3.4 V, VREF = +2.85 V, 50 system) PARAMETER MIN 24.5 22 17 37 8.5 19 TYP 26.5 24.5 20.5 -43 -41 -46 -60 -62 -60 39 9.5 21.5 53 3.8 0.3 <1 -139 -45 -50 MAX 29 27 24 -38 -38 -38 -50 -50 -48 65 5 0.5 5 -137 -30 -30 2:1 UNIT COMMENTS POUT = +27.5 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.85 V POUT = +16 dBm, VCC = 1.5 V, VMODE = +2.85 V POUT = +27.5 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.85 V POUT = +16 dBm, VCC = 1.5 V, VMODE = +2.85 V POUT = +27.5 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.85 V POUT = +16 dBm, VCC = 1.5 V, VMODE = +2.85 V POUT = +27.5 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.85 V POUT = +16 dBm, VCC = 1.5 V, VMODE = +2.85 V VMODE = +2.85 V through VREF pin through VMODE pin, VMODE = +2.85 V VCC = +4.2 V, VREF = 0 V, VMODE = 0 V Gain dB ACLR1 at 5 MHz offset (1) dB c ACLR2 at 10 MHz offset dB c Power-Added Efficiency (1) % Quiescent Current (Icq) Reference Current Mode Control Current Leakage Current Noise in Receive Band Harmonics 2fo 3fo, 4fo Input Impedance mA mA mA A dBm/Hz 2110 MHz to 2170 MHz dB c VSWR POUT < +27.5 dBm In-band load VSWR < 5:1 Out-of-band load VSWR < 10:1 Applies over all voltage and temperature operating ranges VCC = +5.0 V, PIN = +5 dBm Applies over full operating temperature range Spurious Output Level (all spurious outputs) - - -70 dB c Load mismatch stress with no permanent degradation or failure 8:1 - - VSWR Notes: (1) ACLR and Efficiency measured at 1950 MHz. 4 PRELIMINARY DATA SHEET - Rev 1.3 03/2004 AWT6252 APPLICATION INFORMATION To ensure proper performance, refer to all related Application Notes on the ANADIGICS web site: http://www.anadigics.com Shutdown Mode The power amplifier may be placed in a shutdown mode by applying logic low levels (see Operating Ranges table) to both the VREF and VMODE voltages. Bias Modes The power amplifier may be placed in either a Low Bias mode or a High Bias mode by applying the appropriate logic level (see Operating Ranges table) to the VMODE voltage. The Bias Control table lists the recommended modes of operation for various applications. Table 5: Bias Control APPLICATION CDMA - low power CDMA - high power Shutdown POUT LE V E LS <+16dBm >+16 dBm - BIAS MODE Low High Shutdown V R EF VMODE V CC > +1.5 +3.4 - +2.85 V +2.85 V +2.85 V 0V 0V 0V VCC1 VCC2 C1 0.01F RF IN 1 2 3 VCC RFIN GND VMODE VREF VCC GND RFOUT GND GND GND at slug 10 9 8 7 6 C3 0.01F C4 2.2F ceramic RF OUT VMODE VREF 4 5 C2 0.01F Figure 3: Application Circuit Schematic PRELIMINARY DATA SHEET - Rev 1.3 03/2004 5 AWT6252 PACKAGE OUTLINE Figure 4: M7 Package Outline - 10 Pin 4 x 4 x 1.5 mm Surface Mount Module 5 5 Figure 5: Branding Specification 6 PRELIMINARY DATA SHEET - Rev 1.3 03/2004 AWT6252 COMPONENT PACKAGING Figure 6: Tape & Reel Packaging Table 6: Tape & Reel Dimensions PACKAGE TYPE 4 X 4 x 1.5 mm TAPE WIDTH 12mm POCKET PITCH 8mm REEL CAPACITY 2500 MAX REEL DIA 13" PRELIMINARY DATA SHEET - Rev 1.3 03/2004 7 AWT6252 ORDERING INFORMATION ORDER NUMBER TEMPERATURE RANGE PACKAGE DESCRIPTION 10 P i n 4 x 4 x 1.5 mm Surface Mount Module COMPONENT PACKAGING AWT6252M7P8 -10 C to +90 C o o Tape and Reel, 2500 pieces per Reel ANADIGICS, Inc. 141 Mount Bethel Road Warren, New Jersey 07059, U.S.A. Tel: +1 (908) 668-5000 Fax: +1 (908) 668-5132 URL: http://www.anadigics.com E-mail: Mktg@anadigics.com IMPORTANT NOTICE ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without notice. The product specifications contained in Advanced Product Information sheets and Preliminary Data Sheets are subject to change prior to a product's formal introduction. Information in Data Sheets have been carefully checked and are assumed to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders. WARNING ANADIGICS products are not intended for use in life support appliances, devices or systems. Use of an ANADIGICS product in any such application without written consent is prohibited. 8 PRELIMINARY DATA SHEET - Rev 1.3 03/2004 |
Price & Availability of AWT6252M7P8
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |