View PM300DVA120_4110633.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

MITSUBISHI MITSUBISHI
PM300DVA120 PM300DVA120
FLAT-BASE TYPE FLAT-BASE TYPE INSULATED PACKAGE INSULATED PACKAGE
PM300DVA120
FEATURE
* 1 300A, 1200V Current-sense IGBT for 20kHz switching * Monolithic gate drive & protection logic * Detection, protection & status indication circuits for overcurrent, short-circuit, over-temperature & under-voltage (P-FO available from upper leg devices) * Acoustic noise-less 55kW class inverter application * UL Recognized Yellow Card No. E80276(N) File No. E80271
APPLICATION General purpose inverter, servo drives and other motor controls
PACKAGE OUTLINES
120 4-R6.5 106 0.25 10- 0.64
Dimensions in mm
45.5 34
N
76 0.25 90
3-M8NUTS
C2E1 E2 C1
P
5 4 3 2 1
4-6.5 MOUNTING HOLES
28
28
31
3 0.5 2-3.5
73
38.5
5 4 3 2 1
2.54 2.54 2.54 2.54 2.54 2.54 2.54 10.16 2.54
44 TERMINAL CODE 5 : FNO 4 : VNC N 3 : CNI 2 : SNR 1 : VN1 5 : FPO 4 : VPC P 3 : CPI 2 : SPR 1 : VP1
18
18
18
34 -0.5
+1.0
32.8
LABEL
4
31
Jun. 2005
MITSUBISHI
PM300DVA120
FLAT-BASE TYPE INSULATED PACKAGE
INTERNAL FUNCTIONS BLOCK DIAGRAM
VNC CNI SNR FNO VN1 VPC CPI SPR FPO VP1
Ci
Rfo
Ci
Rfo
IN GND SINK SENS
SR
FO VCC GND
IN
SR
FO VCC
Rref
OUT2
OUT1 TEMP
SINK
SENS
OUT2
OUT1 TEMP
AMP
AMP
Rg Th
Rg
E2
C2E1
C1
Ci: 100pF, Rfo: 1.5k MAXIMUM RATINGS (Tj = 25C, unless otherwise noted) INVERTER PART
Symbol VCES IC ICP PC Tj Parameter Collector-Emitter Voltage Collector Current Collector Current (Peak) Collector Dissipation Junction Temperature Condition VD = 15V, VCIN = 5V TC = 25C TC = 25C TC = 25C Ratings 1200 300 600 1260 -20 ~ +150 Unit V A A W C
CONTROL PART
Symbol VD VCIN VFO IFO Parameter Supply Voltage Input Voltage Fault Output Supply Voltage Fault Output Current Condition Applied between : VP1-VPC, VN1-VNC Applied between : CPI-VPC, CNI-VNC Applied between : FPO-VPC, FNO-VNC Sink current at FPO, FNO terminal Ratings 20 10 20 20 Unit V V V mA
Jun. 2005
MITSUBISHI
PM300DVA120
FLAT-BASE TYPE INSULATED PACKAGE
TOTAL SYSTEM
Parameter Supply Voltage Protected by VCC(PROT) SC Symbol VCC(surge) Supply Voltage (Surge) TC Module Case Operating Temperature Storage Temperature Isolation Voltage Condition VD = 13.5 ~ 16.5V, Inverter Part, Tj = 125C Start Applied between : C1-E2, Surge value or without switching (Note-1) Ratings 800 1000 -20 ~ +100 -40 ~ +125 2500 Unit V V C C Vrms
Tstg Viso 60Hz, Sinusoidal, Charged part to Base, AC 1 min. (Note-1) TC measurement point is below. (3mm depth at the center of the side of base plate)
Tc
ELECTRICAL CHARACTERISTICS (Tj = 25C, unless otherwise noted) INVERTER PART
Symbol VCE(sat) VEC ton trr tc(on) toff tc(off) ICES Parameter Collector-Emitter Saturation Voltage FWDi Forward Voltage Test Condition VD = 15V, IC = 300A VCIN = 0V -IC = 300A, VD = 15V, VCIN = 5V VD = 15V, VCIN = 0V5V VCC = 600V, IC = 300A Tj = 125C Inductive Load (upper and lower arm) VCE = VCES, VCIN = 5V Tj = 25C Tj = 125C Tj = 25C Tj = 125C Min. -- -- -- 0.4 -- -- -- -- -- -- Limits Typ. 2.65 2.60 2.50 0.9 0.2 0.4 2.4 0.7 -- -- Max. 3.30 3.25 3.50 2.3 0.3 1.0 3.4 1.2 1 10 Unit V V
Switching Time
s
Collector-Emitter Cutoff Current
mA
CONTROL PART
Symbol ID Vth(ON) Vth(OFF) SC toff(SC) OT OTr UV UVr IFO(H) IFO(L) tFO VSXR Parameter Circuit Current Input ON Threshold Voltage Input OFF Threshold Voltage Short Circuit Trip Level Short Circuit Current Delay Time Over Temperature Protection Supply Circuit Under-Voltage Protection Fault Output Current Minimum Fault Output Pulse Width SXR Terminal Output Voltage VD = 15V, VCIN = 5V Applied between : CPI-VPC, CNI -VNC -20 Tj 125C, VD = 15V VD = 15V Base-plate Temperature detection, VD = 15V -20 Tj 125C VD = 15V, VFO = 15V VD = 15V -20 Tj 125C, Rin=6.8k Trip level Reset level Trip level Reset level (Note-2) (Note-2) Test Condition VN1-VNC VP1-VPC Min. -- -- 1.2 1.7 380 -- 111 -- 11.5 -- -- -- 1.0 4.5 Limits Typ. 27 27 1.5 2.0 -- 10 118 100 12.0 12.5 -- 10 1.8 5.1 Max. 38 38 1.8 2.3 -- -- 125 -- 12.5 -- 0.01 15 -- 5.6 Unit mA V A s C V mA ms V
(Note-2) Fault output is given only when the internal SC, OT & UV protection. Fault output of OT protection operate by lower arm Fault output of OT, UV protection given pulse while over level.
Jun. 2005
MITSUBISHI
PM300DVA120
FLAT-BASE TYPE INSULATED PACKAGE
THERMAL RESISTANCES
Symbol Rth(j-c)Q Rth(j-c)F Rth(c-f) Parameter Junction to case Thermal Resistances Contact Thermal Resistance Test Condition Inverter IGBT part (per 1/2 module) Inverter FWDi part (per 1/2 module) Case to fin, Thermal grease applied (per 1/2 module) Min. -- -- -- Limits Typ. -- -- -- Max. 0.099 0.13 0.065 Unit C/W
MECHANICAL RATINGS AND CHARACTERISTICS
Symbol -- -- -- Parameter Mounting torque Mounting torque Weight Mounting part Main terminal Test Condition screw : M6 screw : M8 Min. 3.92 8.83 -- Limits Typ. 4.90 9.81 720 Max. 5.88 10.8 -- Unit N*m N*m g
RECOMMENDED CONDITIONS FOR USE
Symbol VCC VD VCIN(ON) VCIN(OFF) tdead fPWM Parameter Supply Voltage Control Supply Voltage Input ON Voltage Input OFF Voltage Arm Shoot-through Blocking Time PWM Input Frequency Test Condition Applied across C1-E2 terminals Applied between : VP1-VPC, VN1-VNC Applied between : CPI-VPC, CNI-VNC For IPM's each input signals Recommended value 800 15 1.5 0.8 4.0 3.5 20 Unit V V V s kHz
(Note-3)
Using Application Circuit input signal of IPM, 3 Sinusoidal PWM VVVF inverter (Note-3) With ripple satisfying the following conditions dv/dt swing 5V/s, Variation 2V peak to peak
Jun. 2005
MITSUBISHI
PM300DVA120
FLAT-BASE TYPE INSULATED PACKAGE
PERFORMANCE CURVES
OUTPUT CHARACTERISTICS (TYPICAL) COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL)
COLLECTOR-EMITTER SATURATION VOLTAGE VCE (sat) (V)
400
6
COLLECTOR CURRENT IC (A)
Tj = 25C 300 15V VD = 17V 13V
Tj = 25C Tj = 125C 5 VD = 15V 4 3 2 1 0
200
100
0
0
1
2
3
4
5
0
100
200
300
400
COLLECTOR-EMITTER VOLTAGE VCE (V)
COLLECTOR CURRENT IC(A)
COLLECTOR-EMITTER SATURATION VOLTAGE CHARACTERISTICS (TYPICAL)
SWITCHING CHARACTERISTICS (TYPICAL) 101
7
COLLECTOR-EMITTER SATURATION VOLTAGE VCE (sat) (V)
6 Tj = 25C Tj = 125C 5 IC = 300A 4 3 2 1 0
5
SWITCHING TIME (s)
Tj = 125C VCC = 600V VD = 15V toff ton tc(off)
3 2
100
7 5 3 2
tc(on)
5 7 101 2 3 5 7 102 2 3 5
0
13
14
15
16
17
10-1
CONTROL SUPPLY VOLTAGE VD(V)
COLLECTOR CURRENT IC (A)
COLLECTOR RECOVERY CURRENT -IC (A)
DIODE FORWARD CHARACTERISTICS (TYPICAL) 103
7 5 3 2
2
2
102
7 5 3 2
102
7 5 3 2
trr
10-1
7 5 3 2
101
0
1.0
2.0
3.0
101
5 7 101
2
3
5 7 102
2
3
5
10-2
EMITTER-COLLECTOR VOLTAGE VEC (V)
COLLECTOR RECOVERY CURRENT -IC (A)
Jun. 2005
REVERS RECOVERY TIME trr (s)
Tj = 25C Tj = 125C VD = 15V
REVERSE RECOVERY CURRENT lrr (A)
DIODE REVERSE RECOVERY CHARACTERISTICS (TYPICAL) 103 100 Tj = 25C 7 7 Tj = 125C 5 5 VCC = 600V lrr 3 3 VD = 15V
MITSUBISHI
PM300DVA120
FLAT-BASE TYPE INSULATED PACKAGE
TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (IGBT per 1 element) 101
TRANSIENT THERMAL IMPEDANCE CHARACTERISTICS (FWDi per 1 element) 101
NORMALIZED TRANSIENT THERMAL IMPEDANCE Zth (j - c)
100
NORMALIZED TRANSIENT THERMAL IMPEDANCE Zth (j - c)
7 Single Pulse 5 3 Per unit base = Rth(j - c)Q = 0.099C/ W 2 7 5 3 2 7 5 3 2 7 5 3 2
7 Single Pulse 5 3 Per unit base = Rth(j - c)F = 0.13C/ W 2 7 5 3 2 7 5 3 2 7 5 3 2
100
10-1
10-1
10-2
10-2
10-3 10-3 2 3 5 710-2 2 3 5 710-1 2 3 5 7100 2 3 5 7101 TIME (s)
10-3 10-3 2 3 5 710-2 2 3 5 710-1 2 3 5 7100 2 3 5 7101 TIME (s)
Jun. 2005

▲Up To Search▲

Price & Availability of PM300DVA120

	To Download PM300DVA120 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .