zero cross ac output. for all types of loads 90-240vac control voltage with led internal protection by and clamping voltage. ? ip20 ?relais synchrone sortie ac pr?t ? l'emploi ?commande 90-240vac . led. ?protection interne par rc et ?cr?teur de tension . ?ip20 page 1 / 3 f/gb s/tri/SWT861790/b/12/06/2001 relais statique triphas? three phase solid state relays SWT861790 24 to 520 vac - 3 x 28 arms 5000a 2 s all technical caracteristics are subject to change without previous notice. caract?ristiques sujettes ? modifications sans pr?avis. celduc ? r e l a i s circuit ?quivalent/ equivalent circuit : dimensions / dimensions : 100 110 90 25 110 172 5 led adaptateur / adapter adaptateur / adapter adaptateur / adapter a1 a2 l1/r u l2/s v l3/t w = proud to serve you caract?ristiques de commande (? 20 c) / control characteristics (at 20 c) ac-dc param?tre / parameter symbol min nom max unit tension de commande / control voltage : dc uc 90 240 vdc tension de commande / control voltage : ac uc 90 240 vac courant de commande / control current (@ uc ) ic 4,5 11 ma tension de relachement/ release voltage uc off 15 v r?sistance interne / input internal resistor fig.1 rc 21 k ? tension inverse / reverse voltage urv polarity free v caract?ristiques d'entr?e-sortie (? 20 c) / input-output characteristics (at 20 c) isolement entr?e-sortie/ input-output isolation @500m ui 4000 vrms isolement sortie-semelle/ output-case isolation @500m ui 3300 vrms tension assign?e isolement/ rated impulse voltage uimp 4000 v caract?ristiques g?n?rales / general characteristics param?tre / parameter conditions symbol typ. unit poids/ weight 1900 g plage de temp?rature de stockage / storage temperature range -40 / +100 c plage de temp?rature de fonctionnement/ operating temperature range -40 / +100 c fig1 : caract?ristique d'entr?e / control characteristic 0 20 4 0 6 0 8 0 100 120 140 160 180 200 22 0 24 0 0 0 3 6 9 1 2 0 uc (v) ic (ma) fig. 1 :caract?ristique d'entr?e / control characteristic
caract?ristiques de sortie(? 20 c) / output characteristics (at 20 c) param?tre / parameter conditions symbol typ. unit tension de charge / load voltage ue 400 v rms plage tension de fonctionnement / operating range ( 480vrms + 10% ) uemax 530 v rms tension cr?te / peak voltage up 1200 v niveau de synchonisation / synchronizing level usync 12 v tension d'amor?age / latching voltage ie nom ua 10 v courant nominal ac-51 non permanent/ ac-51 no permanent nominal current ( see fig. 2 ) ie ac-51 75 a rms courant nominal ac-51/ ac-51 nominal current @25 c ( see fig. 2 ) ie ac-51 3x28 a rms courant nominal ac-53/ ac-53 nominal current ( see fig. 2 ) ie ac-53 16 a rms puissance max (moteur triphas?) max 3 pole motor power (400 vac) pn 7,5 kw puissance max (moteur triphas?) 3 pole motor power(400vac)/en60947-2 pn 5,5 kw courant de surcharge non r?p?titif / non repetitive overload current tp=10ms (fig. 3) itsm 1000 a chute tension directe cr?te/ on state voltage drop @ ie nom vd 1,4 v courant de fuite ?tat bloqu?/ off state leakage current @ue, 50hz ilk 2,5 ma courant de charge minimum / minimum load current ie min 5 ma temps de fermeture/ turn on time uc nom dc ,f=50hz ton max 30 ms temps d'ouverture/ turn off time uc nom dc ,f=50hz toff max 30 ms plage de fr?quence / operating frequency range f 10-400 hz dv/dt ?tat bloqu? / off state dv/dt dv/dt 500 v/ s di/dt maximum non r?p?titif/ maximum di/dt non repetitive di/dt 50 a/ s i 2 t (<10ms) i 2 t 5000 a 2 s emc test d'immunit? conduite / conducted immunity level iec 1000-4-4 (burst) 4kv criterion a emc test d'immunit? conduite / conducted immunity level iec 1000-4-5(schocks) 2kv crit.a conformit? / conformity en60947-4-x pr?cautions : * les relais ? semiconducteurs ne procurent pas d'isolation galvanique entre le r?seau et la charge. cautions : * semiconductor relays don't provide any galvanic insu- lation between the load and the mains. s/tri/SWT861790/b/12/06/2001 s urge curren t it sm (a pea k) = f(t) f or mo d e l s w ith it sm = 1000a 1 10 1 0,1 0,01 0 500 1000 1500 0 t (s) itsm (apeak) fig.3 courbes de surcharge de courant / overload current curves 1 -itsm non r?p?titif sans tension r?appliqu?e est donn? pour la d?termination des protections. no repetitive itsm is given without voltage reapplied for the determination of the protection. 2 -itsm r?p?titif est donn? pour des surcharges de courant (tj initiale=70 c). la r?p?tition de ces surcharges de courant diminue la dur?e de vie du relais. repetitive itsm is given for inrush current with initial tj = 70 c. the repetition of the surge cur- rent decrease the lifetime ssr's . no repetitive itsm (apeak)=f(t) without voltage reapplied repetitive itsm (apeak)=f(t) with voltage reapplied for initial tj =70 c caract?ristiques thermiques / thermal curves : 0 10 20 30 40 50 60 70 80 90 100 ambient temperature (?) heatsink max =100? heatsink max = 80? in compliance with en60947-1 0 5 10 15 20 25 30 35 40 45 50 0 10 20 30 40 50 60 70 80 90 100 110 120 rms load current (a) total wasted power (w) full on -state 30% duty cycle 70% duty cycle 50% duty cycle page 2 / 3 f/gb all technical caracteristics are subject to change without previous notice. caract?ristiques sujettes ? modifications sans pr?avis. celduc ? r e l a i s proud to serve you
r e l a i s rue amp?re b.p. 4 42290 sorbiers - france e-mail : celduc-relais@celduc.com fax +33 (0) 4 77 53 85 51 service commercial france t?l. : +33 (0) 4 77 53 90 20 sales dept.for europe tel. : +33 (0) 4 77 53 90 21 sales dept. asia : t?l. +33 (0) 4 77 53 90 19 www.celduc.com celduc ? page 3 / 3 f/gb svt cablage commande / wiring of the control circuit: nombre de fils/ number of wires screwdriver type minimum torque 1 2 tournevis tournevis couple serrage solid (no ferrule) rigide sans embout fine stranded (with ferrule) multibrins avec embouts solid (no ferrule) rigide sans embout fine stranded (with ferrule) multibrins avec embouts n.m 0,75 ... 2,5 mm 2 0,75 ... 2,5 mm 2 0,75 ... 2,5 mm 2 0,75 ... 2,5 mm 2 0,8 x 5,5 mm pozidriv 2 1,2 svt cablage puissance / wiring of the power circuit: number of wires screwdriver type minimum torque 1 2 tournevis tournevis couple serrage solid (no ferrule) rigide sans embout fine stranded (with ferrule) multibrins avec embouts solid (no ferrule) rigide sans embout fine stranded (with ferrule) multibrins avec embouts n.m 1,5 ... 10 mm 2 1,5 ... 6 mm 2 1,5 ... 10 mm 2 1,5 ... 6 mm 2 0,8 x 5,5 mm pozidriv 2 1,8 r st resistive or inductive load rst rst m application typique / typical application : s/tri/SWT861790/b/12/06/2001
|
