 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| data sheet no. pd 10034c series pvn012 microelectronic power ic single pole, normally open, 0-20v, 2.5a ac/ 4.5a dc general description the pvn012 series photovoltaic relay at 100 milliohms features the lowest possible on-state resistance in a miniature package ? lower than a comparable reed relay. the pvn012 is a single-pole, normally open solid- state relay. it utilizes a generationv hexfet output switch, driven by an integrated circuit photovoltaic generator of novel construction. the output switch is controlled by radiation from a gaalas light emitting diode (led) which is optically isolated from the photovoltaic generator. these units exceed the performance capabilities of electromechanical relays in life, sensitivity, stable on- resistance, miniaturization, magnetic insensitivity and ruggedness. they are ideally suited for switching high currents or low level signals without distortion or injection of electrical noise. series pvn012 relays are packaged in a 6-lead molded dip package with either through-hole or surface mount (gull-wing) terminals. they are avail- able in standard plastic shipping tubes or on tape- and-reel. please refer to part identification information opposite. applications portable electronics programmable logic controllers computers and peripheral devices audio equipment power supplies and power distribution instrumentation part identification pvn012 through-hole pvn012s surface-mount PVN012S-T surface-mount, tape and reel (hexfet is the registered trademark for international rectifier power mosfets) features 100m ? on-resistance genv hexfet output bounce-free operation 2.5 - 4.5 amp capacity linear ac/dc operation 4,000 v rms i/o isolation solid-state reliability ul recognized and csa certified esd tolerance: 4000v human body model 500v machine model series pvn012 2 www.irf.com input characteristics limits units minimum control current (see figure 1) 3.0 ma maximum control current for off-state resistance @ t a = +25c 0.4 ma control current range (caution: current limit input led, see figure 6) 3.0 to 25 ma maximum reverse voltage 7.0 v general characteristics limits units minimum dielectric strength, input-output 4000 v rms minimum insulation resistance, input-output, @t a =+25c, 50%rh, 100v dc 10 12 ? maximum capacitance, input-output 1.0 pf maximum pin soldering temperature (10 seconds maximum) +260 ambient temperature range: operating -40 to +85 c storage -40 to +100 connection diagrams output characteristics limits units operating voltage range 0 to 20 v (dc or ac peak) maximum continuous load current @ t a =+40c, 5ma control (see figure 1) a connection 2.5 a (dc or ac) b connection 3.0 a (dc) c connection 4.5 a (dc) maximum pulsed load current @t a =+25c, (100 ms @ 10% duty cycle) a connection 6.0 a (dc or ac) maximum on-state resistance @t a =+25c, for 1a pulsed load, 5ma control (see figure 4) a connection 100 b connection 65 m ? c connection 40 minimum off-state resistance @ t a =+25c, 16v dc 0.16 x 10 8 ? maximum turn-on time @t a =+25c (see figure 7), for 1a, 20 v dc load, 5ma control 5.0 ms maximum turn-off time @t a =+25c (see figure 7), for 1a, 20 v dc load, 5ma control 0.5 ms maximum output capacitance @ 20v dc (see figure 2) 300 pf electrical specifications (-40 c t a +85 c unless otherwise specified ) series pvn012 www.irf.com 3 ! " # " " " ! # figure 1. current derating curves* figure 2. typical output capacitance typical capacitance (pf) max. load current (a) ! " # # $ % & ' load current (a) rd-on (normalized to 25 c) i d-off / i d-off 25 c input current (ma) !"# $% ! &"# % caution: provide current limiting so that 25ma maximum steady state control current rating is not exceeded. led forward voltage drop (volts dc) figure 3. linearity characteristics figure 4. typical normalized on-resistance figure 5. typical normalized off-state figure 6. input characteristics (current controlled) * derating of ? b ? and ? c ? connection at +85 c will be 70% of that specified at +40 c and is linear from +40 c to +85 c. leakage series pvn012 4 www.irf.com figure 7. typical delay times figure 8. delay time definitions led current (ma) delay time (milliseconds) 01-2008 01 case outline series pvn012 www.irf.com 5 ir world headquarters: 233 kansas st., el segundo, california 90245 tel: (310) 252-7105 ir european regional centre: 439/445 godstone rd., whyteleafe, surrey cr3 0bl, united kingdom tel: ++ 44 (0) 20 8645 8000 ir japan: k&h bldg., 2f, 30-4 nishi-ikebukuro 3-chome, toshima-ku, tokyo, japan 171-0021 tel: 8133 983 0086 ir hong kong: unit 308, #f, new east ocean centre, no. 9 science museum road, tsimshatsui east, kowloon hong kong tel: (852) 2803-7380 data and specifications subject to change without notice. 8/5/2000 01-2009 case outline |
Price & Availability of PVN012S-T
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |