bxb150 series single output [ 2 year warranty ] ? industry standard footprint ? mtbf >1.4 million hours (bellcore 332) ? input voltage to ets300-132-2 ? adjustable output voltage ? no minimum load required ? separate case ground pin ? 2:1 input range for battery powered applications ? undervoltage lockout (uvlo) ? ul, vde and csa safety approvals the bxb150 series are high power density dc/dc converters packaged in the industry standard footprint (2.40 x 2.28 x 0.50 inches) to give designers optimum choices when specifying for both new and replacement designs. suitable for a wide range of applications in nearly any industry, the bxb150 was particularly designed with communication and distributed power applications in mind. using bellcore 332, the mtbf is greater than 1,400,000 hours. aluminum baseplate technology with four threaded m3 inserts makes heatsink attachment and optimum thermal management easy. the bxb150 series is approved to iec950 by ul, csa and vde. specification all specifications are typical at nominal input, full load at 25 c unless otherwise stated page 156 output specifications voltage adjustability 60% to 110% set point accuracy 1.0% line regulation low line to high line 0.05% load regulation full load to min. load 0.10% minimum load 0% overshoot at turn-on and turn-off none undershoot none ripple and noise 3.3v and 5v 75mv pk-pk, (5hz to 20mhz) 20mv rms (see note 1) 12v and 15v 100mv pk-pk, 30mv rms temperature coefficient 0.01%/c transient response 2.0% max. deviation (see note 2) 170s recovery to within 1.0% remote sense 0.5vdc transmission line drop compensation input specifications input voltage range 24vin nominal 18 to 36vdc 48vin nominal 36 to 75vdc input current no load 130ma max. remote off 20ma max. input current (max.) 24vin 9.0a max. @ io max. (see note 4) and vin = 0 to 75v 48vin 6.5a max. @ io max. and vin = 0 to 75v input reflected ripple (see note 6) 5ma pk-pk active low remote on/off (see note 7) logic compatibility open collector ref to -input on 1.2vdc max. off open circuit new product input specifications continued undervoltage lockout 24vin: power up 17v 24vin: power down 16.3v 48vin: power up 34v 48vin: power down 32.5v start-up time power up 20ms (see note 8) remote on/off 20ms emc characteristics conducted emissions bellcore 1089 level a (see note 3) fcc part 15 level a en55022, cispr22 level a general specifications efficiency see table isolation voltage input/case 1500vdc input/output 1500vdc output/case 1500vdc switching frequency fixed 500khz typ. approvals and vde0805, en60950, iec950 standards (see note 5) ul1950, csa c22.2 no. 950 case material aluminum baseplate with plastic case material flammability ul94v-0 weight 110g (3.88oz) mtbf bellcore 332 1,400,000 hours mil-hdbk-217f 580,000 hours min. @ 40c, 100% fl environmental specifications thermal performance operating case temp. -40c to +100c non-operating -55c to +125c altitude operating 10,000 feet max. non-operating 40,000 feet max. vibration 5hz to 500hz 2.4g rms (approx.)
notes 1 measured with 10f tantalum capacitor and 1f ceramic capacitor across output. 2 di/dt = 0.1a/1s, vin = 48vdc, tc = 25c, load change = 0.5 lo max. to 0.75 lo max. and 0.75 lo max. to 0.5 lo max. 3 units should be characterised within systems. external components required. 4 input fusing is recommended based on surge current and maximum input current. 5 this product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. 6 simulated source impedance of 12 h. 12 h inductor in series with +vin. 7 active high remote on/off option is available (standard product is active low), designate with the suffix fht e.g. bxb150-48s05fht . consult factory for further details and options. 8 start-up into resistive load. international safety standard approvals vde0805/en60950/iec950 file no. 10401-3336-1095 ul1950 file no. e136005 csa c22.2 no. 950 file no. lr41062c trim up trim down 8 7 6 rt1 or rt2 protection short circuit protection continuous, automatic recovery overvoltage protection non-latching undervoltage protection non-latching thermal protection 110c baseplate, automatic recovery 100 to 150 watt wide input dc/dc converters dc/dc converters | 100-150w dc/dc page 157 http://www.artesyn.com telecom specifications central office interface a ets300-132-2 data sheet ? artesyn technologies ? 2000 the information and specifications contained in this data sheet are believed to be correct at time of publication. however, ar tesyn technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. specifications are subject to change without notice. no rights under any patent accompa ny the sale of any such product(s) or information contained herein. all dimensions in inches (mm) tolerance : x.xx 0.02in. (0.51mm) x.xxx 0.010in. (0.254mm) view shown pin side up 1.90 (48.26) 0.190 (4.83) 0.010 (0.25) 2 x .080 (2.03) 0.002 (0.05) 4 x m3 x 0.5 through 7 x .040 (1.02) 0.002 (0.05) 2.28 (57.91) max. 0.700 (17.77) 1.000 (25.40) 1.400 (35.56) 2.000 (50.80) 0.190 (4.83) 0.010 (0.25) 0.400 (10.16) 0.500 (12.69) 0.010 (0.25) 0.400 (10.16) 1.000 (25.40) 1.400 (35.56) vo(+) +sen trim -sen vo (-) vi(+) on/off case vi (-) 0.200 (5.08) min. length for all input and output pins 0.500 (12.70) 2.40 (60.96) max. pin connections pin number function 1+ vin 2 remote on/off 3 case 4- vin 5 - vout 6 - sense 7 trim 8 + sense 9 + vout please consult our website for the following items: 4 application note 4 simscope? 5 new product external output trimming output can be externally trimmed by using the method shown below. output input ovp output output output efficiency regulation model power voltage voltage current current (typ.) line load number (7) (max.) (min.) (max.) 100w 18-36vdc 4.3vdc 3.3v 0a 30a 77% 0.05% 0.1% bxb150-24s3v3flt 100w 36-75vdc 4.3vdc 3.3v 0a 30a 79% 0.05% 0.1% bxb150-48s3v3flt 150w 36-75vdc 6.5vdc 5v 0a 30a 84% 0.05% 0.1% bxb150-48s05flt 150w 36-75vdc 14.5vdc 12v 0a 12.5a 84% 0.05% 0.1% bxb150-48s12flt 150w 36-75vdc 17.5vdc 15v 0a 10a 88% 0.05% 0.1% BXB150-48S15FLT ds_bxb150_20000101.pdf
|
