published date : feb 28,2008 drawing no : sdsa6358 v1 checked : b.l. liu p.1/4 part number: ZM2CR45FW 3.5x2.8 mm plcc2 smd led www.sunled.com part number emitting color emitting material lens-color luminous intensity (if=20ma) mcd wavelength nm p viewing angle 2 1/2 min. typ. ZM2CR45FW red alingap water clear 650 1495 640 120 absolute maximum ratings (t a =25c ) m2cr (alingap) unit reverse voltage v r 5 v forward current i f 50 ma forward current (peak) 1/10 duty cycle 0.1ms pulse width i fs 150 ma power dissipation p t 140 mw operating temperature t a -40 ~ +85 c storage temperature tstg -40 ~ +85 m2cr (alingap) unit forward voltage (typ.) (i f =20ma) v f 2.2 v forward voltage (max.) (i f =20ma) v f 2.8 v reverse current (max.) (v r =5v) i r 10 ua wavelength of peak emission (typ.) (i f =20ma) p 640 nm wavelength of dominant emission (typ.) (i f =20ma) d 630 nm spectral line full width at half-maximum (typ.) (i f =20ma) ? 25 nm capacitance (typ.) (v f =0v, f=1mhz) c 27 pf operating characteristics (t a =25c ) preliminary spec features z single color. z suitable for all smt assembly and solder process. z available on tape and reel. z ideal for backlighting. z package : 1500pcs / reel. z moisture sensitivity level : level 4. z rohs compliant. notes: 1. all dimensions are in millimeters (inches). 2. tolerance is 0.25(0.01") unless otherwise noted. 3. specifications are subjec t to change without notice.
published date : feb 28,2008 drawing no : sdsa6358 v1 checked : b.l. liu p.2/4 part number: ZM2CR45FW 3.5x2.8 mm plcc2 smd led www.sunled.com ? m2cr
published date : feb 28,2008 drawing no : sdsa6358 v1 checked : b.l. liu p.3/4 part number: ZM2CR45FW 3.5x2.8 mm plcc2 smd led www.sunled.com ? tape specification (units : mm) remarks: if special sorting is required (e.g. binning based on forward vo ltage, luminous intensity / luminous flux, or wavelength), the typical accuracy of the so rting process is as follows: 1. wavelength: +/-1nm 2. luminous intensity / luminous flux: +/-15% 3. forward voltage: +/-0.1v note: accuracy may depend on the sorting parameters. ? recommended soldering pattern (units : mm; tolerance: 0.1) ? the device has a single mounting surface. the device must be mounted according to the specifications.
published date : feb 28,2008 drawing no : sdsa6358 v1 checked : b.l. liu p.4/4 part number: ZM2CR45FW 3.5x2.8 mm plcc2 smd led www.sunled.com packing & label specifications ZM2CR45FW
|