specifications are subject to change without notice (02.02.01) 1 proximity sensors inductive stainless steel housing type ei, m30, high noise immunity ? stainless steel housing, cylindrical ? diameter: m30 ? sensing distance: 9 mm ? hysteresis: 25 - 45% ? power supply: 24 vdc ? output: transistor pnp, make switching ? protection: short-circuit and reverse polarity ? led-indication for output on ? 2 m pur cable, shield connected internaly to housing ? internal 4,7 k , 0,5 w pull down resistor product description netic disturbances. decreased sensitivity to unwanted axle displacements. proximity switch in stainless steel housing m30. made after euronorm en 50 008. high immunity to electromag- type: inductive proximity switch housing diameter (mm) rated operating dist. (mm) output type housing material body style special type number type selection housing body style connection rated operating ordering no. diameter distance (s n ) transistor pnp, make switching m 30 short cable 9 mm 1) ei 3010 pposs 1556 1) for flush mounting in metal make switching = normally open (no) ordering key ei 3010 pposs 1556 specifications rated operational volt. (u e ) 20 to 30 vdc (u b ) 18 to 33 vdc (ripple included) ripple 10% rated operational current (i e ) continuous 200 ma no-load supply current (i o ) output on: < 6.5 ma output off: < 2.7 ma voltage drop (u d ) 2 vdc at max. load protection reverse polarity, short-circuit, transients transient voltage 700 v/0.5 j emc approved according to iec 60947-5-2 power on delay < 10 ms frequency of operating cycles (f) 300 hz indication for output on led, yellow assured operating dist. (s a )0 s a 0.81 s n repeat accuracy (r) 5% hysteresis (h) (differential travel) 25 to 45% of sensing distance effective operating dist. (s r ) 0.9 x s n s r 1.1 x s n usable operating dist. (s) 0.9 x s r s u 1.1 x s r ambient temperature operating -25 to +70c (-13 to +158f) storage -30 to +80c (-22 to +176f) degree of protection ip 67 (nema 1, 3, 4, 6, 13) housing material body stainless steel (1.4301) front grey thermoplastic polyester back black polyester connection cable 3,1 m, 3 x 0.3 mm 2 , grey pur, shield cable weight (cable excluded) 50 g tightening torque 100.0 nm ce-marking ye s
2 specifications are subject to change without notice (02.02.01) ei 3010 pposs 1556 dimensions type a b c d e f sw ? mm mm mm mm mm mm ei 3010 pposs 1556 m 30 x 1.5 x 30 28 30 13.6 15.4 5 36 c de led b f sw a wiring diagrams power supplies power supplies vdc: > ss 130/140. power supplies with amplifier relays: > sv 190. + - 1 bn 4 bk 3 bu installation hints relief of cable strain protection of the sensing face switch mounted on mobile carrier to avoid interference from inductive voltage/ current peaks, separate the prox. switch pow- er cables from any other power cables, e.g. motor, contactor or solenoid cables incorrect correct the cable should not be pulled a proximity switch should not serve as mechanical stop any repetitive flexing of the cable should be avoided
|
