1 www.protekdevices.com 05080.r4 12/02 telecom diode bridge/ tvs arra y applica tions ? t1/e1 & t3/e3 line cards ? isdn u-interfaces & isdn s/t interfaces ? xdsl interfaces ? ethernet - 10/1000 base t iec compa tibility (en61000-4) ? 61000-4-2 (esd): air - 15kv, contact - 8kv ? 61000-4-4 (eft): 40a - 5/50ns ? 61000-4-5 (surge): 8/20s - l4, 95a(line-gnd), l1, 48a(power) & l4, 48a(line-line) fea tures ? esd protection > 40 kilovolts ? 2000 watts peak pulse power per line (t p =8/20s) ? low capacitance - 18pf ? 100a (2/10s) per bellcore 1089(intra-building) mechanical characteristics ? molded jedec so-8 ? weight 0.1 grams (approximate) ? flammability rating ul 94v-0 ? 12mm tape and reel per eia standard 481 ? marking: logo, marking code, date code & pin number 1 indicated by dot on top of package circuit diagram so-8 05080 . . . engineered solutions for the transient environment? plc03-6 1 2 3 4 8 7 6 5
2 www.protekdevices.com plc03-6 05080.r4 12/02 device characteristics maximum ratings @ 25c unless otherwise specified operating temperature symbol value -55 c to 150 cc c -55 c to 150 c units t j t stg parameter storage temperature peak pulse power (t p = 8/20s) - see figure 1 p pp 2000 w atts note 1: for an 8/20s waveform, apply positive pulse to pin 1 or 8 to pin 2 or 3(ground). note 2: measured between pin 1 ro 8 to pin 2 or 3; pin 1 or 8 to pin 4 or 5. note 3: measured between i/o pins and ground (pin 1 to 2). note 4: measured between i/o pins (pins 1 to 4). electrical characteristics per line @ 25c unless otherwise specified pa rt number rated stand-off voltage v wm volts minimum breakdown voltage @ 1ma v (br) volts maximum clamping voltage (note 1 & 2) (see fig. 2) @8/20s v c @ i pp maximum capacitance (see note 4) 0v @ 1 mhz c pf plc03-6 6.0 6.8 20.0v @ 100.0a 8 maximum leakage current @v wm i d a 25 device marking code pba 16 typical capacitance (see note 3) 0v @ 1 mhz c pf
3 www.protekdevices.com 05080.r4 12/02 plc03-6 graphs 0 5 10 15 20 25 30 t - time - s 0 20 40 60 80 100 120 i pp - peak pulse current - % of i pp test waveform parameters t f = 8s t d = 20s t f peak value i pp e -t figure 2 pulse wave form 0 25 50 75 100 125 150 t l - lead temperature - c 20 40 60 80 100 % of rated power peak pulse power 8/20s average power figure 3 power derating curve 0 0.01 1 10 100 1,000 10,000 t d - pulse duration - s 0.1 1 10 100 p pp - peak pulse current - kilowatts figure 1 peak pulse power vs pulse time 2000w, 8/20s waveform i pp /2 t d = t
4 www.protekdevices.com plc03-6 05080.r4 12/02 copyright ? protek devices 2003 specifications: protek reserves the right to change the electrical and or mechanical characteristics described herein without notice (except jedec). design changes: protek reserves the right to discontinue product lines without notice, and that the final judgement concerning selection and specifications is the buyer?s and that in furnishing engineering and technical assistance, protek assumes no responsibility with respect to the selection or specifications of such products. package outline & dimensions a b c d f g j k p r 4.80 3.80 1.35 0.35 0.40 1.27 bsc 0.18 0.10 5.80 0.25 5.00 4.00 1.75 0.49 1.250 1.27 bsc 0.25 0.25 6.20 0.50 0.189 0.150 0.054 0.014 0.016 0.05 bsc 0.007 0.004 0.229 0.010 0.196 0.157 0.068 0.019 0.049 0.05 bsc 0.009 0.008 0.244 0.019 dim min max min max millimeters inches package dimensions notes: 1. - t - = seating plane and datum surface. 2. dimensions ?a? and ?b? are datum. 3. dimensions ?a? and ?b? do not include mold protrusion. 4. maximum mold protrusion is 0.015? (0.380 mm) per side. 5. dimensioning and tolerances per ansi y14.5m, 1982. 6. dimensions are exclusive of mold flash and metal burrs. -a- p -b- d g 8 5 4 1 -t- k c r x 45 o j f 0 o - 10 o 0.010? (0.25 mm) m b m 4 pl 0.010? (0.25 mm) s b m 8 pl t a s package outline so-8 0.030? 0.005? 0.050? 0.005? 0.160? 0.005? 0.045? 0.005? 0.245? min mounting pad 06009 rev 1 -11/01 protek devices 2929 south fair lane, tempe, az 85282 tel: 602-431-8101 fax: 602-431-2288 e-mail: sales@protekdevices.com web site: www.protekdevices.com t ape & reel ordering informa tion: surface mount product is taped and reeled in accordance with eia-481. suffix -t7: 7 inch reel - 1,000 pieces per reel (i.e., plc03-6-t7). suffix -t13: 13 inch reel - 2,500 pieces per reel (i.e., plc03-6-t13). no suffix: bulk quantities - 98 pieces per tube.
|
