pomona ? all dimensions are in inches. tolerances (except noted): .xx = .02? (,51 mm), .xxx = .005? (,127 mm). all specifications are to the latest revisions. specifications are subject to change without notice. r egistered trademarks are the property of their respective companies. made in usa 6/9/99 pomona access 90106 (800) 444 - 6785 or (425) 446 - 6010 sy/eh/ls more drawings available at ww w.pomonaelectronics.com s: \ engineering \ release \ datasheets \ flukedatasheet \ d_ai_4859_2_01.doc page 1 of 2 model 4859 & as sembly instructions sma male plug sales: 800 - 490 - 2361 fax: 888 - 403 - 3360 technical assistance: 800 - 241 - 2060 features: accepts cable types rg55, 142 materials: body and fitting ? steel per qq - s - 764, type 303. center contact ? brass per qq - b - 626, alloy 360, ? hard dielectric ? teflon per l - p - 403 gaskets and seals ? silicone rubber per zz - r - 765 finis h: body and fitting ? passivated steel center contact ? gold plated per requirements of mil - c - 39012 ratings: nominal impedance: 50 ohms frequency range: dc to 18 ghz ordering information: model 4859 cabling instructions furnished on request.
pomona ? all dimensions are in inches. tolerances (except noted): .xx = .02? (,51 mm), .xxx = .005? (,127 mm). all specifications are to the latest revisions. specifications are subject to change without notice. r egistered trademarks are the property of their respective companies. made in usa 6/9/99 pomona access 90106 (800) 444 - 6785 or (425) 446 - 6010 sy/eh/ls more drawings available at ww w.pomonaelectronics.com s: \ engineering \ release \ datasheets \ flukedatasheet \ d_ai_4859_2_01.doc page 2 of 2 model 4859 & as sembly instructions sma male plug sales: 800 - 490 - 2361 fax: 888 - 403 - 3360 technical assistance: 800 - 241 - 2060 f igure #1 a. slide shrink tubing and crimp sleeve over cable. b. strip cable as shown. c. flair braid outward slightly by rotating dielectric. figure #2 d. place center contact over center conductor provide gap as shown and solder. figure #3 e. place connector body over contact, sliding barrel under braid. f. push sleeve up against the body of the connector and crimp. figure #4 g. push shrink tubing over crimped sleeve so it touches the connector body and shrink the sleeve using a heat gun or equivalent.
|