cage code 06324 ?2011 glenair, inc. printed in u.s.a. 40 series 72 guardian glenair, inc. ? 1211 air way ? glendale, ca 91201-2497 ? 818-247-6000 ? fax 818-500-9912 connector strap wrench t g70 connector strap wrench with 3/8" square d rive 3 . 000 (76.2) d ia . ma x. w it h 18 i nc h si ng le s tr ap 2 . 000 d ia . (50.8) ma x. w it h 12 i nc h si ng le s tr ap 3 .00 0 (76.2) d ia . ma x. 3 /8 s qu ar e dr iv e, f or t or qu e wr en ch 6 00 -0 04 6 .5 00 (165.1) ap pr ox g l e n a i r i n c . t g 7 0 6.5 (165.1) approx. 3/8 (9.5) square drive for t orque wrench gtsq150 3.0 (76.2) diameter max. with 18 inch strap 2.0 (50.8) diameter max. with 12 inch strap how to order basic number torque wrench (omit for none) strap length in inches available in 12 and 18 inches. omit for standard 12 inches TG70 - p - 18 variance chart notes: recommended installation torque is approximately 80% of mil-c-85049 accessory thread strength values. heavy duty installation torque values may be difcult to attain with the TG70 strap wrench; the values shown in brackets [ ] are the maximum attainable with the TG70 strap wrench. glenair recommends using 600 series torque tools whenever possible when torque loading exceeds 75 inch pounds, or to attain the heavy duty torque values shown. material and finish: wrench handle: alunminum alloy/nickel plate wedge: stainless steel/passivated strap: impregnated fabric notes: replacement straps are available. specify part number g70515-xx for 12 or 18 inch strap. not recommended for composite coupling nuts. use 600-091 or 600-157. double wrap for heavy duty range variance chart t g70 strap wrench used with glenair t orque wrenches accessory shell size recommended i nstallation torque light/ m edium duty 5 inch pounds heavy duty 5 inch pounds TG70 torque part torque TG70 torque part torque 08/09 f8 35 45 60 10/11 f8 35 70 80 1f/13 30 40 75 110 [80] 14/15 30 40 75 1f0 [80] 16/17 30 40 75 1f0 [80] 18/19 30 40 75 1f0 [80] f0/f1 75 80 95 140 [100] ff/f3 75 80 1f0* 140 f4/f5 75 80 1f0* 140 f8 135* 150 3f 150* 150 36 150* 150 *TG70 not recommended for values of 1f0 inch lbs. or greater.
|
