http://www.optosupply.com ver a.0 x x e e o o n n 5 5 p p o o w w e e r r w w h h i i t t e e l l e e d d osxxxde5e1e ver c.0 features highest luminous flux super energy efficiency long lifetime operation superior esd protection superior uv resistance applications read lights (car, bus, aircraft) portable (flashlight, bicycle) bollards / security / garden traffic signaling / beacons in door / out door commercial lights automotive ext absolute maximum rating 5 b
directivity *pulse width max.10ms duty ratio max 1/10 electrical -optical ch aracteristics 5 b
v f (v) per segment or (dp) i r (a) cct (k) luminous flux v (lm) d(nm) 2 1/2 (deg) min. typ. typ. max. typ min. typ. max. min. typ. max. part number color i f =1400ma v r =10v i f =1400ma osw4xde5e1e pure white w4 3.3 3.5 4.0 10 6500 300 320 - x=0.31 ,y=0.33 OSM5XDE5E1E warm white m5 3.3 3.5 4.0 10 3000 280 300 - x=0.45,y=0.41 140 va l u e item symbol white/ warm white 6 o j u dc forward current i f 1600 ma pulse forward current* i fp 2000 ma reverse voltage v r 10 v power dissipation p d 6400 mw operating temperature topr -30 ~ +85
storage temperature tstg -40~ +100
lead soldering temperature tsol 260
/5sec
note: don?t drive at rated current more than 5s without heat sink for xeon 3 emitter series. led & application technologies # b d l 7 j f x 6 o j u n n 5 p m f s b o d f ? n n " o p e f $ b u i p e f & 4 % 1 s p u f d u j p o % j p e f
http://www.optosupply.com ver a.0 x x e e o o n n 5 5 p p o o w w e e r r w w h h i i t t e e l l e e d d osxxxde5e1e ver c.0 handling of silicone lens leds notes for handling of silicone lens leds please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. the leds should only be picked up by making contact with the sides of the led body. avoid touching the silicone lens especially by sharp tools such as tweezers. avoid leaving fingerprints on the silicone lens. please store the leds away from dusty areas or seal the product against dust. when populating boards in smt production, there are basica lly no restrictions regarding the form of the pick and place nozzle, except that mechan ical pressure on the silicone lens must be prevented. please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) led & application technologies
|
