shrouded power relay f4 a plug-in relays mini iso relays catalog 1308028-2 revised 1-2009 all specifications subject to change. consult tyco electronics for latest specifications. 59 features limiting continuous current 40 a at 85? pin assignment according to iso 7588 part 1 bracket customized versions on request integrated components (e.g. diode) customized marking typical applications abs control blower fans cooling fan energy management engine control fuel pump heated front screen ignition lamps front, rear, fog light main switch/supply relay wiper control please contact tyco electronics for relay application support. design elv/rohs/weee compliant shrouded: protection class ip67 to iec 529 (en 60 529) if used with special connector weight approx. 60 g (2.1 oz.) nominal voltage 12 v or 24 v; other nominal voltages available on request terminals quick connect terminals similar to iso 8092-1, coil and load 6.3 x 0.8 mm; surfaces tin plated accessories fitting connectors see table ordering information conditions all parametric, environmental and endurance tests are performed according to eia standard rs-407-a at standard test conditions unless otherwise noted: 23? ambient temperature, 20 - 50% rh, 998.9 ?3.9 hpa. for general storage and processing recommendations please refer to our application notes and especially to storage in the ?lossary page 23 or at http://relays.tycoelectronics.com/ appnotes/ 136_3d03 disclaimer all technical performance data apply to the relay as such, specific conditions of the individual application are not considered. please always check the suitability of the relay for your intended purpose. we do not assume any responsibility or liability for not complying herewith. we recommend to com plete our questionnaire and to request our technical service. any responsibility for the application of the product remains with the customer only. all specifications a re subject to change without notification. all rights of tyco electronics are reserved.
shrouded power relay f4 a plug-in relays mini iso relays catalog 1308028-2 revised 1-2009 all specifications subject to change. consult tyco electronics for latest specifications. 60 view of the terminals (bottom view) dimensional drawing 10,9 1 0 , 9 0,5 0 , 5 6,7 6 , 7 30 te136_dd1 17,9 1 7 , 9 0,25 0 , 2 5 0,25 0 , 2 5 35,2 3 5 , 2 0,3 8,3 6 8 , 3 6 0,25 0 , 2 5 32,4 3 2 , 4 16,8 1 6 , 8 10,32 1 0 , 3 2 0,3 0 , 3 0,25 0 , 2 5 te136_vt2 1,5 1 , 5 max. m a x . 4,6 0,5 6,4 0,5 0 , 5 3,2 0,1 0 , 1 39,6 3 9 , 6 24 0,5 0 , 5 54,2 5 4 , 2 11 0,5 0 , 5 te136_dd2 5,5 te136 _ bv1 te136_dd5
shrouded power relay f4 a plug-in relays mini iso relays catalog 1308028-2 revised 1-2009 all specifications subject to change. consult tyco electronics for latest specifications. 61 contact data contact configuration circuit symbol rated voltage rated current limiting continuous current 23? 85? 125? contact material max. switching voltage/power max. switching current 1) on 2) off min. recommended load 3) voltage drop at 10 a (initial) no contact nc contact mechanical endurance (without load) electrical endurance (example of resistive load, further information on request) max. switching rate at nominal load 1) the values apply to a resistive or inductive load with suitable spark suppression and at maximum 13.5 v for 12 v or 27 v for 24 v load voltages. 2) for a load current duration of maximum 3 s for a make/break ratio of 1:10. 3) see chapter diagnostics of relays in our application notes page 31 or consult the internet at http://relays.tycoelectronics.com /appnotes/ 1 make contact/ 1 changeover contact/ 1 form a 1 form c 12 v 12 v 40 a 30/40 a nc/no 60 a 45/60 a 40 a 30/40 a 17 a 12/17 a silver based see load limit curve nc/no 120 a 45/120 a 60 a 40/60 a 1 a at 12 v typ. 15 mv, 300 mv max. typ. 15 mv, 300 mv max. typ. 25 mv, 300 mv max. typ. 10 7 operations > 2 x 10 5 operations > 1 x 10 5 operations 40 a on no 40 a on no 6 operations per minute (0.1 hz) load limit curve load limit curve 1 ^ = arc extinguishes during transit time (changeover contact) load limit curve 2 ^ = safe shutdown, no stationary arc (make contact)
shrouded power relay f4 a plug-in relays mini iso relays catalog 1308028-2 revised 1-2009 all specifications subject to change. consult tyco electronics for latest specifications. 62 coil 114,0 ohm, 680 ohm parallel resistor 0 5 10 15 20 25 30 -40 -20 0 20 40 60 80 100 120 ambient temperature in c coil voltage in v umax uop (e=13,5v) uop (e=0v) 136_ovr1 does not take into account the temperature rise due to the contact current e = pre-energization mechanical data cover retention axial force 150 n pull force 200 n push force 200 n terminals pull force 100 n push force 100 n circuit diagram ar 1 make contact/1 form a with resistor cr 1 changeover contact/1 form c with resistor 5 3 1 2 54 3 1 2 coil data available for nominal voltages 12 v nominal power consumption at nominal voltage with suppression resistor 1.5 w test voltage winding/contact 500 vac rms ambient temperature range ?0 to +125? operate time at nominal voltage typ. 8.5 ms release time at nominal voltage 1) typ. 4 ms 1) for unsuppressed relay coil. note: a low resistive suppression device in parallel to the relay coil increases the release time and reduces the lifetime caused by increased erosion and/or higher risk of contact tack welding. operating voltage range
shrouded power relay f4 a plug-in relays mini iso relays catalog 1308028-2 revised 1-2009 all specifications subject to change. consult tyco electronics for latest specifications. 63 environmental conditions temperature range, storage test climatic cycling with condensation temperature cycling damp heat cyclic constant corrosive gas vibration resistance shock resistance load dump jump start drop test flammability overload current for relays with rated currents as shown in contact data table 2) protection class 1) fmvss: federal motor vehicle safety standard. 2) current and time are compatible with circuit protection by a typical automotive fuse. relay will make, carry and break the specif ied current. refer to storage in the ?lossary catalog page 23 or http://relays.tycoelectronics.com/appnotes/ relevant standard testing as per dimension comments en iso 6988 6 cycles storage 8/16 h iec 68-2-14 nb 10 cycles ?0/+85? (5? per min) iec 68-2-30 db, variant 1 6 cycles upper air temperature 55? iec 68-2-3 ca 56 days iec 68-2-42 10 ? cm 3 /m 3 so 2 10 days iec 68-2-43 1 ?.3 cm 3 /m 3 h 2 s 10 days iec 68-2-6 (sine sweep) 10 - 500 hz no change in the min. 5 g switching state > 10 s iec 68-2-27 (half sine form single pulses) min. 20 g valid for nc contacts, 11 ms no contact values significantly higher iso 7637-1 (12 v) test pulse 5 vs = +86.5 v iso 7637-2 (24 v) test pulse 5 vs = +200 v 24 v for 5 minutes conducting nominal current at 23? capable of meeting specifications after 1.0 m (3.28 ft) drop onto concrete ul94-hb or better (meets fmvss 302) 1) 1.35 x rated current 1800 s 2.00 x rated current 5 s 3.50 x rated current 0.5 s 6.00 x rated current 0.1 s iec 529 (en 60 529) ip67 if used with special connector ordering information part numbers (see table below for coil data) circuit/contact contact enclosure coil fitting connectors relay description part number arrangement material suppression fci order number V23136-B1001-X051 1-1414121-0 ar/1 form a silver based shrouded cover resistor 680 6 043 01 01 v23136-a1001-x057 1-1414552-0 cr/1 form c silver based shrouded cover resistor 680 6 043 01 41 coil data coil must must for rated coil resistance 2) operate release allowable overdrive 1) shrouded voltage ?0% voltage voltage voltage (v) power f4 a (v) ( ) (v) (v) at 23? at 85? v23136-**001-**** 12 96 7.2 1.6 24 18 1) allowable overdrive is stated with no load applied and minimum coil resistance. 2) resistance measured between terminals 1 and 2. coil versions standard delivery packs (orders in multiples of delivery pack) shrouded power f4 a: 108 pieces
|
