643 spectrum microwave ? 2144 franklin drive n.e. ? palm bay, florida 32905 ? phone: (888) 553-7531 ? fax: (888) 553-7532 spectrum control gmbh ? hansastrasse 6 ? 91126 schwabach, germany ? phone: (49)-9122-795-0 ? fax: (49)-9122-795-58 mixers microwave a spectrum control business s p e c t r u m inc. www.specwave.com parameter ssb conversion loss: (2) (3) image rejection side- band suppression: (4) amplitude match phase match isolation lo to rf: lo to i/q: rf to i/q: i/q to rf: input 1-db compression point: input third order intercept point: lo power: (5) i/q mixer / modulator communications band lo(ghz) 7.0-12.7 5.5-13.5 9.5-12.7 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 rf(ghz) 7.0-12.7 5.5-13.5 9.5-12.7 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 5.5-13.5 if(mhz) dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 dc-500 min 20 db 16 db 20 db 25 db typical 5.0 db 5.3 db 28 db 25 db 0.2 db 5 deg 25 db 35 db 28 db 40 db +5 dbm +8 dbm +12 dbm +14 dbm +17 dbm +21 dbm +10 dbm +13 dbm +17 dbm max 6.5 db 7.0 db miq64 miq66 miq67 miq64 miq66 miq67 miq64 miq66 miq67 conditions specifications electrical specifications (1) : model miq6xsmd-1 rf 5.5 to 13.5 ghz lo power 4 = +10 dbm 6 = +13 dbm 7 = +17 dbm notes: 1. specifications are guaranteed when tested as a downconverter in a 50 ohm system at +25 ? c with the nominal lo power. specifications indicated as typical are not guaranteed. 2. noise figure is typically within 0.5 db of conversion loss for if frequencies greater than 10 mhz. 3. conversion loss typically degrades less than 0.5 db at +100 ? c and improves less than 0.5 db at -55 ? c. conversion loss is the combined value. 4. measured with an if quadrature hybrid whose amplitude and phase errors are 0.5 db and 3 degrees maximum. an if quadrature hybrid is not included. 5. usable lo drives are up to 2 db below to 3 db above nominal. 6. see application notes m112, for aid in selecting the outline and for mounting and installation information. typical performance at 25 ? c note: see pc board footprint - fp3 on page 3-64 all dimensions are in inches and [mm]. outline: smmc8 miq6xsmd-1
|
