1030 mhz resonator 0.2 mhz bandwidth part number MN95031 idt saw products 324 clark street, worcester, ma 01606, usa ph 1-508-852-5400 fax 1-508-852-8456 www.idt.com dsMN95031 rev - 14-sep-2009 ecn 36522 page 1 of 3 amp 10 db/div amp 1 db/div center = 1028 mhz, 2 mhz/div (50 khz incr) description 1030 mhz saw resonator (single pole) with 0.2 mhz bandwidth. 5 x 5 mm ceramic lcc, 8 pads. rohs compliant. typical performance s11 (1020-1040 mhz) s22 (1020- 1040 mhz) center = 1030 mhz , 2 mhz/div ( 50 khz incr)
1030 mhz resonator 0.2 mhz bandwidth part number MN95031 idt saw products 324 clark street, worcester, ma 01606, usa ph 1-508-852-5400 fax 1-508-852-8456 www.idt.com dsMN95031 rev - 14-sep-2009 ecn 36522 page 2 of 3 specification parameter min typ max units center frequency (fc, at 10db points) 2,3 1029.95 1030 1030.1 mhz insertion loss - 9.2 15 db 3 db bandwidth 0.2 0.23 - mhz 10 db bandwidth - 0.75 - mhz insertion phase 1, 2 - 0 - deg device delay - 0.93 - us turn over temperature (tc) - 45 - c source and load impedance - 50 - w ambient temperature (t) - 23 - c notes: 1. measured at 1030 mhz. 2. specifications apply at an ambient temperature of 23c +/- 5c. 3. frequency versus temperature will be according to the following: dfc/fc = -0.032 ppm * (t-tc) 2 where (dfc/fc) = change in center frequency (in ppm ) and t = temperature (in degrees c). tc = the turnover temperature. maximum ratings parameter min max units storage temperature range -40 125 ?c operating temperature range (t) -30 100 ?c input power level - +13 dbm matching circuit notes: 1. external matching components are not required. 2. device is to operate in a 50 ohm single-ended s ystem. 1 5 all other pads input 50 w single-ended output 50 w single-ended gnd gnd
1030 mhz resonator 0.2 mhz bandwidth part number MN95031 idt saw products 324 clark street, worcester, ma 01606, usa ph 1-508-852-5400 fax 1-508-852-8456 www.idt.com dsMN95031 rev - 14-sep-2009 ecn 36522 page 3 of 3 package outline suggested footprint marking iso 9001 registered all specifications are believed to be accurate and reliable. however, mnc reserves the right to make changes without notice. ? 2009 all rights reserved. package material: body: al 2 o 3 ceramic lid: kovar, ni plated terminations: au plating 1 m min, over a 1.3-8.9 m ni plating units: mm tolerances are 0.15 mm except for the overall length and width, which are nominal values. pad configuration: input: 1 output: 5 ground: all other pads idt 95031 ? yyddd esd symbol (denotes pad 1) date code (yy=year, ddd=day)
|