logic table input ctrl ctrl 1 ctrl 2 0 0 all off 0 1 j1 - j2 1 0 j1 - j3 1 1 j1 - j4 function rev. - / iss. 1 iso (db) i.l. (db) typical performance at 25 c vswr 100 80 60 40 20 0 0 0.8 1.6 2.4 3.2 4.0 1.0 1.2 1.4 1.6 1.8 2.0 1 4 10 40 100 400 1000 3000 frequency (mhz) vswr iso i. loss parameter min typ max units conditions operating frequency 2 2500 mhz dc current 11 30 ma at +15 vdc supply 5 30 ma at -12.5 vdc supply control type ttl 2 line, see logic chart control current high 1. 020 a vih = +2.7v low 1.0 -400 a vil = +0.5v isolation 50 70 db insertion loss 1.40 1.7 db 2 - 1000 mhz 2.15 3 db 1000 - 2500 mhz amplitude balance 0.1 0.3 db reference between the calibration port and any input port of the switch phase tracking: port to 0.5 2 deg 2 - 1000 mhz port (max differential) 1.5 10 deg 1000 - 2500 mhz vswr thru 1.25/1 1.4/1 termination 1.1/1 1.5/1 impedance 50 ohms switching speed 3.7 10 sec 50% ttl to 90% / 10% rf transition (rise/fall) time 1.5 10 sec 10% / 90% or 90% / 10% rf switching (video) transients 0.18 0.30 1.0 v com when switched to all off intercept points 2nd +73 +88 dbm 1.3 mhz / 2.3 mhz 3rd +38 +47 dbm 1.3 mhz / 1.6 mhz rf power operate +28 +20 dbm 0.1 db compression no damage +30 dbm operating temperature -55 +25 +85 cta guaranteed performance cntl 2 50 ? j1 com j2 cal 50 ? "1" "0" cntl 1 +15v -12.5v gnd gnd 50 ? j3 j4 .50 .13 1.750 .25 .18 4-40 thread x .12 min deep, 2 places connector sma female 4 places part cal identification com cntl2 cntl1 +15v -12.5v j4 j3 .32 max 0.03 dia solder terminal, 4 pls .45 1.20 1.05 2.00 1.75 j2 j1 gnd terminal 4 places .58 .78 .98 1.18 .18 .38 .xx = .02 .xxx = .010 model no. CSW36333 gaas sp3t features 2 - 2500 mhz 70 db isolation 0.1 db amplitude tracking port-to-port 0.5 degrees phase tracking port-to-port all-off-state sp3t daico industries
|