1 technical data sheet bnc twinax jack connector clamp/solder attachment for rg108, 78 ohm twinax confguration connector bnc t winax jack connector specifcation mil-c-39012 connector interface type rg108,78 ohm twinax cable attachment method (shield/contact) clamp/solder body style straight electrical specifcations impedance, ohms 78 mechanical specifcations temperature operating range, deg c -65 to +165 size length, in [mm] 1.17 [29.72] width/dia., in [mm] 0.57 [14.48] . weight, lbs [g] 0.041 [18.6] connector type bnc twinax jack contact material and plating silver contact plating specifcation qq-s-365 body material and plating brass, nickel dielectric type t efon compliance certifcations (visit www.pasternack.com for current document) rohs compliant y es plotted and other data notes: v alues at 25 c, sea level bnc twinax jack connector clamp/solder attachment for rg108, 78 ohm twinax from pasternack enterprises has same day shipment for domestic and international orders. our rf, microwave and fber optic products maintain a 99% availability and are part of the broadest selection in the industry. click the following link (or enter part number in search on website) to obtain additional part information including price, inventory and certifcations: bnc twinax jack connector clamp/solder attachment for rg108, 78 ohm twinax PE4237 url: http://www.pasternack.com/bnc-twinax-jack-standard-rg108-78-ohm-twinax-connector-PE4237-p.aspx PE4237 PE4237 rev bnc twinax jack connector clamp/solder attachment for rg108, 78 ohm twinax
? 2013 pasternack enterprises all rights reserved 2 PE4237 rev scale n/a dwg title cad file 147 fscm no. 53919 rev. - 042309 size a PE4237 notes: 1. unless otherwise specified all dimensions are nominal. 2. all specifications are subject to change without notice at any time. 3. dimensions are in inches [mm]. 4. fits mil-c-17 and equivalent cables. 1. slide clamp nut (1), washer (2) & gasket (3) over cable. strip cable to dimension shown. do not nick braid & dielectric. comb out braid. taper end of braid to permit assembly of braid clamp (4) . slide braid clamp (4) over braid & butt against jacket. form braid over clamp nut (4). trim braid flush with shoulder of braid clamp (4). 2. strip cable to dimension shown. slide small washer (5) & rear insulator (6) over dielectrics. solder contacts (7) to center conductor through hole in contact. clean excess solder. slide front insulator (8) over contacts. slide assembly forward into body & tighten. assembly procedures * when soldering contacts make sure same sex is on both ends of wire identified by the bare copper wire. bnc twinax jack connector clamp/solder attachment for rg108, 78 ohm twinax PE4237 cad drawing
|
