tsv-300w series led drivers constant voltage aluminum housing electrical specifcations input voltage range: 277 - 480 nom. vac (249 - 528 v min/max) frequency: 50/60 hz nom. (47-63 hz min/max) power factor: 0.90 @ full load, 277v through 480v inrush current: 135 amps max @ 480 vac, cold start 25oc input ac current: 1.4 a max 277vac, 0.8 a max 480vac maximum power: 300w output voltage tolerance: 3% line regulation: 1% vac load regulation: 1.5% output current leakage current: 0.75 ma 480vac 50hz typical effciency 90-91% at 277vac turn-on delay: 1 s typical ripple and noise: 2% v o protection: over-current (hiccup mode), over-temperature (latch mode), lightning, and short circuit protection (hiccup mode) environmental specifcations minimum starting temp: -35oc maximum case temp. 83c storage temperature: -40oc to +85oc humidity: 5% to 100% cooling: convection sound rating: class a mtbf: 250,000 hours at 480vac input, 80% load and 25oc ambient conditions per mil-hdbk-217f lifetime: 62,000 hours @ 480v, 80% load, tc = 60oc weight: 3.09 lbs. (1.4 kg) constant voltage - product specifcations model number output voltage (vdc 3%) output current range (ma) max. output power (w) typical effciency TSV-300S024ST 24 0-12.5 300 90% tsv-300s028st 28 0-10.7 300 91% tsv-300s036st 36 0-8.33 300 91% tsv-300s048st 48 0-6.25 300 91% e332160 safety and emc compliance ul/cul ul8750, ul1012, csa-c22.2 no. 107.1 ce en61347-1, en61347-2-13 en 55015 conducted emission test & radiated emission test en 61000-3-3 voltage fuctuations & ficker fcc part 15 ansi c63.4:2009 class b en 61000-4-2 electrostatic discharge (esd): 8 kv air discharge, 4 kv contact discharge en 61000-4-3 radio-frequency electromagnetic field susceptibility test-rs en 61000-4-4 electrical fast transient / burst-eft en 61000-4-5 surge immunity test: ac power line: line to line 4kv, line to earth 6kv en 61000-4-6 conducted radio frequency disturbances test-cs en 61000-4-8 power frequency magnetic field test en 61000-4-11 voltage dips en 61547 electromagnetic immunity requirements applies to lighting equipment rev 8-27-15 ? total power: 300 watts ? input voltage: 277-480 vac nom. ? ul dry & damp location rated ? ip67 ? high power factor * ul8750, iec61347 specifcations subject to change without notice. note: led drivers are designed and intended to operate led loads only. non-led loading may be outside the specifed design limits of our led drivers, and therefore cannot be covered by any warranty. if you desire to use our led drivers to operate non-led loads please contact us to discuss compatibility. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com
pg 2 of 2 ac input (3*awg18) black (acl) white (acn) green (gnd) dc ouput (2*awg14) red (v+) blue (v-) 30 case temperature (c) lifetime (khrs) lifetime/case temperature 0 45 30 15 60 75 90 105 120 135 40 50 60 70 80 90 derating curve load (%) 100 80 60 40 20 0 ambient temperature (c) 277v a c 480v a c -10 0 10 20 30 40 50 60 70 normalized output voltage pf power factor / output voltage 60% 70% 80% 90% 100% 50% normalized output voltage thd thd / output voltage 60% 70% 80% 90% 100% 277v a c 480v a c 277v a c 347v a c 480v a c 0.60 0.65 0.80 0.75 0.70 0.85 0.95 0.90 1.00 0% 15% 10% 5% 20% 40% 35% 30% 25% efficiency / load 75% 60% 85% 95% 100% 70% 65% 80% 90% normalized output voltage efficiency 60% 70% 80% 90% 100% 277v a c 480v a c tsv 300w series note: disconnect power to led driver for at least 30 seconds before connecting or disconnecting driver output and led engine. this prevents potential arcing transients that can damage the engine and driver. see hot plugging in our driver application guide for more information. thomas research products ? 1225 bowes rd ? elgin, il 60123 ? t 847-515-3057 ? f 847-515-3047 ? www.trpssl.com ssl solutions faster than the speed of light ?
|
