313 process yellow 3405 1797 1375 116 2607 652 242 2985 375 240 embedded power for business-critical continuity smt10e series 3.0 - 5.5 vin special features ? 10 a current rating ? input voltage range: 3.0 vdc to 5.5 vdc ? output voltage range: 0.8 vdc to 3.63 vdc ? ultra high effciency: 96% @ 5 vin and 3.3 vout ? extremely low internal power dissipation ? minimal thermal design concerns ? designed in reliability: mtbf of >7 million hours per telcordia sr-332 ? ideal solution where board space is at a premium or tighter card pitch is required ? industry standard surface-mou nt footprint ? available rohs compliant ? 2 year warranty total power: 13.2 watts input voltage: 3.0 - 5.5 vdc # of outputs: single safety ? ul/cul can/csa 22.2 no. e186249 ? tv product service (en60950) certifcate no. b 08 05 51485 378 ? cb report and certifcate to de3-51686m1 rev.3.4.09_90 smt10e_05 series 1 of 4 input input voltage range: 3.0-5.5 vdc input current: no load 70 ma typ. input current (max.): 8 a max. @ lo max. and vout = 3.63 v input current ripple: 110 ma rms remote on/off: (see note 2) start-up time: 20 ms output voltage adjustability: (see note 1) fixed output versions wide trim version 10% 0.8 - 3.63 vdc setpoint accuracy: 0.4% line regulation: 0.2% load regulation: 1.0% minimum load: 0 a overshoot/undershoot: none ripple and noise: 0 to 20 mhz bw 50 mv pk-pk 25 mv rms max. temperature co-effcient: 0.01%/?c transient response: 60 mv max. deviation 50s recovery to within 1.0% remote sense: 10% vo compensation electrical specifcations all specifcations are typical at 5 vin and 3.3 vout, full load at 25 c unless otherwise stated.
rev.3.4.09_90 smt10e_05 series 2 of 4 embedded power for business-critical continuity 313 process yellow 3405 1797 1375 116 2607 652 242 2985 375 240 emc characteristics environmental specifcations thermal performance: (see note 3) operating ambient temperature -40 c to +100 c non-operating -40 c to +125 c electrostatic discharge: en61000-4-2, iec801-2 conducted immunity: en61000-4-6 radiated immunity: en61000-4-3 effciency: see table insulation voltage: non-isolated switching frequency: fixed 300 khz typ. approvals and standards: en60950 ul/cul60950 material fammability: ul94v-0 dimensions (l x w x h) 33.02 x 13.46 x 8.21 mm 1.3 x 0.53 x 0.323 inches weight: 6.3 g (0.22 oz) coplanarity: 100 m mtbf: telcordia sr-332 mil-hdbk-217f 7,042,000 hours 680,000 hours general specifcations protection short circuit: continuous thermal: automatic recovery
rev.3.4.09_90 smt10e_05 series 3 of 4 embedded power for business-critical continuity 313 process yellow 3405 1797 1375 116 2607 652 242 2985 375 240 all specifcations are typical at 5 vin and 3.3 vout, full load at 25 c unless otherwise stated. ordering information smt10e-05s3v3j part number system with options rated output current 10 = 10 amps input voltage 05 = 3.0 vdc to 5.5 vdc type of output s = single w = wide output voltage 1v2 = 1.2 v, 1v5 = 1.5 v, 1v8 = 1.8 v, 2v5 = 2.5 v, 3v3 = 3.3 v the ultra-wide output voltage trim range offers major advantages to users who select the smt10e-05w3v3j. it is no longer necessary to purchase a variety of modules in order to cover different output voltages. the output voltage can be trimmed in a range of 0.8 vdc to 3.63 vdc. when the smt10e-05w3v3j converter leaves the factory the output has been adjusted to the default voltage of 3.3v. ? when vin 4.5 v, then vout can be adjusted from 0.8 vdc to 3.6 vdc ? when vin < 4.5 v, then vout can be adjusted from 0.8 vdc to 2.75 vdc output voltage adjustment of the smt10e-05w3v3j series product family smt = surface-mount performance e = enhanced performance packaging options (4) j = pb-free (rohs 6/6 compliant) ordering information output power (max.) input voltage output voltage output currents efficiency (typ.) regulation model numbers (2, 4, 5) min max line load 13.2 w 3.0 - 5.5 vdc 1.2 vdc 0 a 10 a 89% 0.2% 1.0% SMT10E-05S1V2J (eol) 16.5 w 3.0 - 5.5 vdc 1.5 vdc 0 a 10 a 90% 0.2% 1.0% smt10e-05s1v5j (eol) 19.8 w 3.0 - 5.5 vdc 1.8 vdc 0 a 10 a 92% 0.2% 1.0% smt10e-05s1v8j (eol) 27.5 w 3.0 - 5.5 vdc 2.5 vdc 0 a 10 a 95% 0.2% 1.0% smt10e-05s2v5j (eol) 36.3 w 4.5 - 5.5 vdc 3.3 vdc 0 a 10 a 96% 0.2% 1.0% smt10e-05s3v3j (eol) 36.3 w 3.0 - 5.5 vdc 0.8 - 3.63 vdc 0 a 10 a 96% 0.2% 1.0% smt10e-05w3v3j notes 1 when vin 4.5 v, then vout can be adjusted from 0.8 vdc to 3.6 vdc. when vin < 4.5 v, then vout can be adjusted from 0.8 vdc to 2.75 vdc. 2 the smt10e features a negative logic remote on/off operation. if not using the remote on/off pin, leave the pin open (the converter will be on). the remote on/off pin is referenced to ground. the following conditions apply for the smt10e: confguration converter operation remote pin open circuit unit is on remote pin pulled low unit is on remote pin pulled high [von/off >1.2 v] unit is off a positive logic remote on/off version is also possible with this converter. to order please place the suffx -r at the end of the model number, e.g. smt10e-05w3v3-rj. notes continued 3 full derating curve s available in both the longform datasheet and application note 168. 4 tse rohs 5/6 (non pb-free) compliant versions may be available on special request, please contact your local sales representative for details. 5 notice: some models do not support all options. please contact your local emerson network power representative or use the on-line model number search tool at http://www.powerconversion.com to fnd a suitable alternative.
313 process yellow 3405 1797 1375 116 2607 652 242 2985 375 240 embedded power for business-critical continuity rev.3.4.09_90 smt10e_05 series 4 of 4 si de view connector (6pl ) width : 0.112 0.003 (2.84 0.08) length : 0.062 0.002 (1.57 0.04) 1.3000.010 (33.02 0.25) 0.039 (1.00) 0.530 0.010 (13.46 0.25) bo tt om vi ew 0.190 (4.83) 0.190 (4.83) 0.190 (4.83) 0.310 (7.87) 0.039 (1.00) to p vi ew all dimensions in inches (mm) all tole ranc e 0.010in (0.25 mm) unless othe rw ise stated 5 43 2 6 1 0.430 (10.92) 0.048 (1.22) 0.075 (1.91) 0.405 (10.29) 0.297 (7.54) 0.323 (8.21) installed ht. 0.007 (0.18) min cl ea rance max . compone nt se ating pl ane americas 5810 van allen way carlsbad, ca 92008 usa telephone: +1 760 930 4600 facsimile: +1 760 930 0698 europe (uk) waterfront business park merry hill, dudley west midlands, dy5 1lx united kingdom telephone: +44 (0) 1384 842 211 facsimile: +44 (0) 1384 843 355 asia (hk) 14/f, lu plaza 2 wing yip street kwun tong, kowloon hong kong telephone: +852 2176 3333 facsimile: +852 2176 3888 for global contact, visit: www.powerconversion.com techsupport.embeddedpower @emerson.com while every precaution has been taken to ensure accuracy and completeness in this literature, emerson network power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. emerson network power and the emerson network power logo are trademarks and service marks of emerson electric co. ?2008 emerson electric co. emersonnetworkpower.com embedded computing embedded power monitoring outside plant power switching & controls precision cooling racks & integrated cabinets services surge protection emerson network power. the global leader in enabling business-critical continuity. ac power connectivity dc power pin connections pin number function pin 1 remote on/off pin 2 remote sense + pin 3 trim pin 4 +vout pin 5 ground pin 6 +vin mechanical drawing
|
